As a car enthusiast, there's nothing more satisfying than restoring a car's beauty and giving it a new lease on life. However, the restoration process is not without its challenges, and one of the most common is dealing with small dents, dings, and scratches on the car's surface. Fortunately, using body fillers such as UPOL Easy or Evercoat EZ Ultralite can make the job of repairing these imperfections easy and straightforward.
In this blog, we will explore how to mix and apply body filler using UPOL Easy and Evercoat EZ Ultralite.
Step 1: Prep the Surface
Before you start mixing and applying the body filler, it's essential to prepare the surface you want to repair. This involves cleaning the area with soap and water to remove any dirt, grease, or other contaminants. You should also sand the area lightly to create a rough surface for the filler to adhere to.
Step 2: Mix the Body Filler
The next step is to mix the body filler. Both UPOL Easy and Evercoat EZ Ultralite are two-part fillers that require mixing before use. You should follow the manufacturer's instructions on the packaging to mix the filler correctly. Generally, the mixing ratio depends on the ambient temperature, around 20°C will the manufacturers recommend 2% hardener to body filler. It isn't much, so typically take a golf ball size of body filler with a generous tooth bush load of a hardener. Obviously, it's cooler than 20°C, be sure to mix more. At cooler temperatures the hardener will take longer to go off.
Next, give it a good thorough mix using a plastic or metal spreader card.
Step 3: Apply the Body Filler
Once you have mixed the body filler, it's time to apply it to the surface you want to repair. You should use a plastic spreader to apply the filler in a smooth, even layer. Start by spreading the filler over the damaged area and then feather it out around the edges to blend it in with the surrounding surface.
Step 4: Sand the Filler
After the filler has dried, you should sand it to smooth out any imperfections and create a level surface. Start with a coarse sandpaper and gradually work your way up to a finer grit sandpaper until the surface is smooth and level.
Step 5: Prime and Paint
Once you have sanded the filler, you should prime the surface and then paint it to match the surrounding area. You can use a spray can or a paint gun to apply the primer and paint.
Using UPOL Easy and Evercoat EZ Ultralite can make repairing small dents and dings on your car's surface a breeze. By following these steps, you can mix and apply the body filler like a pro and give your car a professional-looking repair. Remember to follow the manufacturer's instructions and take your time to ensure the best results. If you're looking for Body Filler check our recommended Top 10 Body Filler.
